Reads the chip, restarts the board and reads which firmware it runs and its settings.
Tips
- Use a data USB-C cable. A board that never shows up usually has a charge-only cable.
- Rev C.2 station: plug into its USB-C port (it shows up as a CH340 serial port). No setup mode needed; the keyboard can stay plugged in.
- MH truck unit: plug into the Heltec's USB-C on the TH station board. It runs the pager firmware (keys: MH = ACK, TL = UP, SUP = DOWN, MAINT = ESC) and shows up as "MH truck unit".
- TH prototypes listen on USB for 3 minutes after boot. Identify restarts the board, so that's handled.
- If the chip can't be read, hold PRG (BOOT), tap RST, let go of PRG and try again.
Identify a board first.
Flashing needs the admin PIN (Admin tab).
Developer: flash my own app.bin
Uses the bootloader and partition table of the version selected above, with your app.bin instead of its app.
History
The current build for each board, grouped by what it's for. Older builds are kept under each board's archive. The Android master app reads the same firmware/index.json.